foofoofoofoofoofoofoofoofoofoofoofoofoofoofoofoofoofoofoofoofoofooAsset 3foofoofoofoofoofooairporthospitalsindustrylogisticsretailArtboardempowermentAsset 1Asset 2innovationbrochureproductpassionproductsrespectAsset 3teamworkArtboard@2xwhitepaperwiring-diagramsfacebookinstagramlinkedintwitteryoutubearrowarrow-redux-bigarrow-redux-toparrow-redux-toparrow-reduxarrowArtboard@2xcountrydownloadeyefile2filtergridhamburgerlanguagelistnopdfphoneplusresetsearchsubscribevideoyesArtboard@2x


Presence sensor for industrial doors
Technology Active Infrared


The MILAN is an active infrared sensor working on the principle of the ground reflectivity analysis. Its mission is to increase the protection of the door by avoiding every collision with vehicles standing close to the door area. Moreover, the MILAN adjustment allows to define small and accurate detection areas in front of the door: 40 active infrared spotlights covering 3 m × 3 m* in front of the door.


Reliable protection

Increased protection of vehicles and pedestrians and improvement of the door protection and reduction of collision risks.


Possibility to adjust the detection area and the minimal size of the target and 2 relay outputs enabling to run motion and presence detection separately.


Immunity against door vibrations and interferences.

Designed for industiral environments

IP65, rugged housing and installation till 6 m high depending on size and nature of the target

Detection field
Table of specifications

Supply voltage:

12V to 24V AC ±10%; 12V to 24V DC +10% / -3%


Power consumption:

< 3.5 W / VA


Mains frequency:

50 to 60 Hz


Max. contact voltage:
Max. contact current:
Max. switching power:

2 relays (free of potential change-over contact)
42 V AC/DC
1 A (resistive)
30 W (DC) / 42 VA (AC)


Output holdtime:

0.5 s


Mounting height:

2.5 m - 6 m*


Temperature range:

from -30 °C to + 60 °C



0 - 95% non condensing


Degree of protection:




127 mm (L) x 102 mm (H) x 96 mm (W)



ABS and polycarbonate



400 g


Cable lenght:

10 m


Norm conformity:

EN 61000-6-2; EN 61000-6-3; EN 50581



active infrared


Transmitter frequency/wavelength:

875 nm


Transmitter power density:

< 250 mW/m²


Detection mode:

motion & presence


Detection field:

4 m x 4 m (emitting spots**)


Min. detection speed:

5 cm/s to activate detection


Reaction time:

250 ms


Tilt angle:

This product conforms to all applicable European Union legislation. Please refer to the Declaration of Conformity for further information.


* depending on size and nature of target
** zone detected by Spotfinder, slightly bigger than actual detection field
Specifications are subject to changes without prior notice – Measured in specific conditions.

  • milan

    Presence sensor for industrial doors

need more information Contact us